Rotating a flat region around a line creates a solid of revolution. Slices perpendicular to the rotation axis become disks or washers. Their radii are distances from the axis, so the axis must be included in every geometric setup.
A washer is an outer disk minus an inner disk
If a slice has outer radius R and inner radius , its area is Therefore, for perpendicular x-slices,
A disk is the special case The difference is between squared radii, not the square of their difference. The expression would describe a disk with radius equal to the washer's thickness, a different shape.
Horizontal axes usually pair with vertical slices and dx; vertical axes pair with horizontal slices and dy. These slices are perpendicular to the axis, which is the defining feature of the washer method.
Example: a disk around the x-axis
Rotate the region under and above for around the x-axis. Each vertical slice touches the axis, so there is no hole. Its radius is
The boundary height is a radius because it is measured from the axis If the axis moved, that same height would no longer equal the radius.
Example: washers around a shifted axis
Rotate the region between and on around On this interval, is the upper curve. The axis is below both curves, so the farther boundary is the upper curve:
The volume is
Expanding the difference gives Its integral is so
The hole is real: each slice begins one unit above the axis at its lower boundary, rather than extending to the axis. Omitting the inner radius would fill that hole and overstate the volume.
The region between square root of x and x on zero to one is shown above the horizontal rotation axis y equals minus one. At x equals one quarter the outer height is one half and inner height one quarter.
The rotation axis is below the region. Radii are measured from , so each boundary height must have 1 added.
Describe this figure
The region between square root of x and x on zero to one is shown above the horizontal rotation axis y equals minus one. At x equals one quarter the outer height is one half and inner height one quarter.
Marked points: Outer boundary: filled marker at (0.25, 0.5); Inner boundary: filled marker at (0.25, 0.25).
Lines: Rotation axis.
A vertical axis changes the slicing variable
Rotate the region between and for around the y-axis. A horizontal slice extends from to so the outer radius is and inner radius
The setup is The bounds are y-values because the thickness is dy. Mixing x-bounds into this expression would mismatch the geometry.
Measure distance, not signed height
For rotation about a point at height has radius Which boundary is farther can change if the axis crosses the region or if the region crosses the axis. A slice crossing the axis may create a full disk rather than a washer, and its radius is the larger of the two distances.
Draw a representative slice and its rotation. If outer and inner roles switch, split the integral at that location. Do not mechanically label “top” as outer: when the axis is above the region, the bottom boundary is farther away.
Rotation above the region reverses the outer boundary
If the region between and on is rotated about the farther boundary is the lower line The outer radius is and the inner radius is 1, so the setup is
This contrasts with rotation about the x-axis in the checkpoint. The same planar region can produce different radii and volumes under different axes. Always draw the axis before naming outer and inner boundaries.
Try it yourself
Rotate the region between and for around the x-axis. Find the volume.
Answer: The outer radius is 2 and the inner radius is . Thus The slice at has a circular hole of radius , so subtract its area before integrating.
What to remember
Choose slices perpendicular to the axis, measure radii as distances from that axis, and integrate outer squared minus inner squared. A sketch determines whether each slice is a disk or washer.