Unit conversion is multiplication by a carefully chosen form of one. Thinking this way lets you handle several conversion steps without guessing whether to multiply or divide, and it helps expose answers with impossible units.
Use a conversion factor whose units cancel
Because 1 meter equals 100 centimeters, the ratio equals one as a physical quantity. Multiplying 2.4 meters by it gives
The meter units cancel, leaving centimeters. Reversing the factor would leave the wrong units. Write the starting quantity, choose factors that remove unwanted units, and check the unit remaining at the end.
Metric conversions use powers of ten. Common customary conversions include 12 inches per foot, 3 feet per yard, 5,280 feet per mile, 16 ounces per pound, and 4 quarts per gallon. Do not assume customary systems use a uniform base.
Example: convert a mixed measurement
A board measures 5 feet 7 inches. In inches it is In feet it is or approximately 5.583 feet. It is not 5.7 feet: the fractional part of a foot is measured in twelfths.
If three such boards are placed end to end, their total length is inches. Dividing by 12 gives 16 feet with 9 inches left over. Converting to one unit before multiplying avoids difficult regrouping.
The same principle applies to hours and minutes. A duration of 2 hours 15 minutes is 135 minutes, or 2.25 hours, not 2.15 hours.
Example: elapsed time across noon
A bus leaves at 11:48 a.m. and arrives at 2:17 p.m. From 11:48 to noon is 12 minutes. From noon to 2:00 p.m. is 120 minutes, and another 17 minutes reaches the arrival time. Total elapsed time is 149 minutes, or 2 hours 29 minutes.
You can also use a 24-hour clock: 2:17 p.m. becomes 14:17. Subtracting 11:48 requires borrowing one hour as 60 minutes, producing 13 hours 77 minutes minus 11 hours 48 minutes. The result is again 2 hours 29 minutes.
If an event crosses midnight, account for the new day rather than treating the ending clock number as smaller elapsed time. Time-zone differences, when supplied, must also be separated from actual travel duration.
Money uses hundredths, but repeated rounding can matter
A ticket costs 7.85 dollars. Four tickets cost dollars. Paying with 40 dollars gives 8.60 dollars in change. You can work in cents to keep every operation integral, or align decimal points when working in dollars.
When a percentage charge or discount is involved, follow the stated rounding policy. If no intermediate rounding is requested, keep precision until the final amount. Rounding each item and rounding only the total can occasionally differ by a cent.
Area and volume need squared and cubed factors
If 1 meter equals 100 centimeters, one square meter is a 100-by-100 square of square centimeters: A cubic meter similarly contains cubic centimeters.
The exponent on the unit changes the conversion factor. Multiplying an area by only 100 would convert one direction while leaving the other unconverted. A diagram of the unit square explains why both directions matter.
For rates, convert numerator and denominator. A speed of 3 meters per second is meters per minute, because one minute contains 60 seconds. The larger time unit collects more distance at the same speed.
Try it yourself
A runner covers 600 meters in 2 minutes 30 seconds. Find the average speed in meters per second. Convert a square with side 2 meters to an area in square centimeters.
Answer: The time is 150 seconds, so speed is meters per second. The square's side is 200 centimeters, so its area is square centimeters.
What to remember
Treat conversions as unit cancellation, keep mixed measurements in compatible units, and apply the correct factor to lengths, areas, volumes, and rates.