A sinusoidal model describes a quantity that rises and falls in a repeating, approximately smooth pattern. Building the model means translating observations into a midline, amplitude, period, and starting position, then checking whether the resulting wave fits the context.
Read vertical information from extremes
If the observed maximum is M and minimum is , the midline and amplitude are
The midline is the level halfway between extremes. The amplitude measures the distance from that level to either extreme, not the full maximum-to-minimum difference.
If one complete cycle takes T time units, the angular coefficient is This converts elapsed time into a radian angle that advances by during one cycle.
A convenient model with a maximum at time C is taking A positive. A minimum at C can be modeled with negative cosine, and an upward midline crossing with sine.
Example: a Ferris wheel height
A Ferris wheel has lowest passenger height 2 m and highest height 26 m. One revolution takes 40 seconds, and the passenger starts at the lowest point at time zero.
The center height is m and the radius, or amplitude, is m. The period gives Starting at a minimum suggests
Check physical anchors. At equal to zero, cosine is 1 and height is 2. At 10 seconds, the angle is and height is 14. At 20 seconds, cosine is and height is 26. At 40 seconds, the passenger returns to height 2.
The negative sign is not a negative radius. It chooses the starting position of the motion.
The passenger starts at 2 m, reaches 26 m after 20 s, and returns after 40 s.
The passenger starts at 2 m, reaches 26 m after 20 s, and returns after 40 s.
Describe this figure
The passenger starts at 2 m, reaches 26 m after 20 s, and returns after 40 s.
Marked points: Start: filled marker at (0, 2); Top: filled marker at (20, 26); filled marker at (40, 2).
Lines: Center height.
Example: use an observed peak time
A water level varies between 1.5 m and 4.5 m, with successive high levels 12 hours apart. A high level occurs at 3 a.m. Let measure hours after midnight.
The midline is 3 m, amplitude 1.5 m, and period 12 hours. A suitable model is
At equal to 3, height is 4.5. At equal to 9, the angle has advanced by producing the low level 1.5. The next high is at equal to 15, which is 3 p.m.
A sine model shifted by a quarter-period could describe the same pattern. Models with different-looking phase shifts can be equivalent; compare their predictions rather than their appearance alone.
Use the model to answer a question
For the Ferris wheel, when is the passenger at center height during the first revolution? Set Then so the relevant angles are and The times are 10 and 30 seconds.
There are two answers because the passenger passes center height while rising and while falling. A single inverse-cosine calculator output would not supply both automatically.
The context also restricts time. Negative times or times after the requested revolution may solve the equation mathematically but not answer the question asked.
Recognize model limitations
Real data may not repeat perfectly. Tides combine several influences; temperatures can show irregular weather changes; machinery can change speed. A sinusoidal model is useful when the repeating structure is appropriate over the interval of interest.
Check several observations, not just the extrema used to create the formula. If the period drifts or the rising and falling portions differ strongly, a single sine wave may be inadequate. Avoid extending a short observed pattern indefinitely without justification.
Try it yourself
A quantity ranges from 8 to 20, repeats every 6 hours, and is at a maximum at equal to 1. Write a cosine model and find the next minimum time.
Answer: Midline 14, amplitude 6, and give A minimum comes half a period after a maximum, so the next is at equal to 4.
What to remember
Use extremes for vertical features, cycle length for frequency, and a meaningful starting event for phase. Then verify the model against both additional data and the physical situation.